Using the Custom Updates URL method, there are two different ways SpinFire Ultimate checks if there are new updates to download and install
The default configuration uses a URL to an Actify server to find the updates through the Internet.
However, in some scenarios a user(s) may not have access to the Internet or their organization may want to control desktop systems by preventing updates.
The Use Custom Updates URL setting provides the means to control where updates are obtained.
To use the Use Custom Updates URL setting:
For every release of SpinFire Ultimate there are two sets (one for 32-bit and one for 64-bit) of update files:
Decide on the location of the update files. The 64-bit version of the files must be in a "x64" folder and the 32-bit files in a "x86" folder.
If I am updating from my local hard drive and I choose "c:\actfiy\update" as the folder to update from then each set of the update files should be moved to the following folders:
The custom updates URL setting must point to "C:\Actify\Update". SpinFire figures out if you're updating a 32-bit version or 64-bit version.
Note: If you already know that you (and your users) are only updating the 64-bit version then the update files for the 32-bit version are not needed.
An organization can also have a common location on a network share.
Decide on the location of the update files. In this example, I chose "\\MyNetwork\MyShare\Actify" to place the update files. Also I must make sure the users updating from this location have read access and their DNS can resolve the name/location (valid IP addresses can be used as well).
So the update files should be moved to the following folders:
The custom updates URL setting must point to "\\MyNetwork\MyShare\Actify".
Tip: Set the Check for Updates to Never and point the User Custom Updates URL to older versions of update files on a network share to prevent your user base from updating to a new version of SpinFire Ultimate.
To obtain SpinFire Ultimate update files from Actify Support: